bestpriceddecals web store FAQ section

Decals and dots can be applied to almost any semi-smooth surface (not brick or stucco)- the possibilities are endless! The vinyl is easily removed when you are ready for a change. Application instructions are included with each order. Dots do not come with application tape as it is easy to just pull off (like a sticker) and put them right on the wall.

Simple Instructions for applying your Decal: Step #1 Lay your wall decal onto a hard flat surface with the translucent transfer sheet facing up. Pressing firmly use the plastic squeegee included to scrape across the decal surface. This will ensure that your wall decal is completely fixed to the transfer sheet. Then, repeat this process, but turn the decal face down so you are now pressing and scraping the squeegee across the white backing paper. Step #2 Carefully peel back the white sheet so that the wall decal is left on the translucent transfer sheet and the sticky side is facing out. If parts of the wall decal remain on the white sheet push the sheet back onto the transfer sheet to rub the area for a few seconds to adhere it to the transfer sheet. Step #3 Gently place the transfer sheet with your wall decal onto a smooth clean surface in the position desired. Once you have it in the exact position you would like lightly smooth your hand across the surface to semi mount the piece. Now, pressing firmly, use the plastic squeegee to rub across the surface of the transfer paper from the center out to ensure removal of any air bubbles. Step #4 After a few minutes of rubbing the material, carefully remove the transfer sheet by pulling the sheet away but parallel to the wall. If any part of the wall decal sticks on the sheet push the sheet back onto the wall and rub the area for a few seconds with the squeegee.